How To Replace Water Pump Ford Tempo 1993 Youtube

If your h2o pump is leaking this guide can be used equally reference for replacement.

Signs:

-When my water pump began to get out I notice I was running low on coolant and my heat took longer than normal to become hot.
-Another sign was my coolant overflow tank was empty later 1 day.
-Coolant leaking on ground
-Coolant dripping from bottom of creepo pulley (water pump has failed)

The coolant appearing to drip from the lesser of your crank caster is actually coming from the water pump weep pigsty on the bottom.

The stuff you lot demand:

Water pump
H2o pump gasket
Bolt grease
Sealant
Gasket Scraper
Flat caput spiral driver
Steel wool
Rag
Saucepan
Cardboard
1/2in socket (can employ 13mm)
ane/2in wrench
three/eighth's drive socket (don't utilize 1/2in drive)

Now if your water pump has been on a while or you just don't know when it was replaced last the bolts may be stuck. Some have said they've snapped a commodities. To avoid this be sure to spray the bolts with PB Blaster or WD-twoscore, Now start the car and let the motor warm up to break the bolts loose.

In that location are iv bolts on the water pump pulley. Loosen the bolts while the belt is yet on.(use 1/2 wrench)

Remove the belt. Now finish removing the bolts on the pulley. Y'all volition need a hammer to tap the caster loose.

Now loosen the ii hoses attached to the top left of the water pump. Loosen them on both end. They may be tough to remove. Apply a flat head spiral driver to pry the hose off being careful not to harm the hose. Now put the saucepan under the car and remove the lower radiator hose.

Now use the 3/8ths socket wrench and 1/2in socket to remove the water pump bolts. You will need to use extension for some of the bolts During this time remove the idler caster's pulley the top left commodities will not come up out without it removed. Remove the water pump.

Outline your new water pump on the cardboard you thought yous didn't need. Marker where the water pump commodities holes are. Put the bolts in the holes to keep up with where they go. Every bolt is a unlike length

Now here's where the gasket scraper comes in. Accept your time while scraping. It took me 45minutes to go information technology smoothen. Once all the erstwhile gasket is off smoothen the surface with your steel wool.

Now take a look at the weep hole on your water pump. Found the culprit?

Clean off your bolts with Pb Blaster and steel wool

Use the RTV Silicone and spread information technology on your new water pump gasket encompass the entire thing! Line upwardly the gasket and identify it on your h2o pump and press information technology downward snug.

Your non done spreading yet....spread sealant on the other side at present

Now driblet the pump down and bolt it in. Be sure to grease the bolts so they don't rust. Tighten the pump downwards in an alternating fashion and ensure everything is snug

Now put the hoses and stuff back on my friend

Put some coolant, burp the arrangement. I normally use my Lev-R-Vent radiator cap to assistance bleed air out of the cooling system

Whatsoever way...that's it.

That was my first time replacing the h2o pump and it took all of 3 hours.

Source: https://www.sn95forums.com/threads/how-to-water-pump-replacement-5-0-specific.63832/

Posted by: jaroszgerentow90.blogspot.com

Share this post